Sangean DDR-31BT (V1) Manuale Utente Scaricare il pdf (Pagina 32)

Factory reset

If your clock radio fails to operate correctly or some digits on the display

are missing or incomplete, carry out the following procedures.

1. Press and release the On/StandBy button to switch on your clock radio.

2. Press and hold the Advanced button to enter the setting.

3. Press the Tuning Up or Down buttons until the display shows “System”.

4. Press and release the Select button to enter the adjustment mode.

5. Press the Tuning Up or Down buttons until the display shows “Factory

reset”.

6. Press and release the Select button to enter the Factory reset menu.

7. Press the Tuning Up or Down buttons to select the option of <No> or

<Yes>.

8. Press the Tuning Up or Down buttons to select YES, then press and

release the Select button to start the Reset, the display will appear

“Restarting…”.

9. A full reset will be performed, the station list and presets will be erased.

The display will show “Welcome to Digital Radio“ for a few seconds

and then the ash clock digits and the display will show “Time is not

set”. When the factory reset is complete, you can set new settings.

In case of malfunction due to electrostatic discharge, reset the product

(reconnection of power source may be required) to resume normal

operation.

1 2 ... 27 28 29 30 31 32 33 34 35 36

Nessun commento

Sangean DDR-31BT (V1) Manuale Utente Pagina 32